RadioLAN DockLINK Manual de usuario descargar pdf (Pagina 16)

Testing the Data Range

To test for best signal quality, locate a temporary wireless

station in the location at which you intend to locate the

DockLINK. Use the NODE DISCOVERY page at each wireless

station on the network to verify signal quality. Also test locations

where fixed wireless stations are not normally located, such as

conference rooms.

As you test each location, note the signal strength measured on

the NODE DISCOVERY page (see Figure 4). In the event that you

discover a location where signal quality is low, there are three

basic options for action:

1. If most or all station locations report a low-quality signal,

relocate the DockLINK.

2. If one or only a few station locations report a low-quality

signal, relocate the antennas at weak locations to improve

signal quality.

DockLINK Station

Signal Quality

Figure 4: Testing Data Range

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 117 118

Sin comentarios

RadioLAN DockLINK Manual de usuario Pagina 16